FAQ - Controller
1. This product uses magnetic charging to reduce friction between terminals.
2. When the charging cable connector is closed to the charging port of the remote/controller, the charging connector automatically connects in order to charge. The charging time is 3 hours.
2. When the charging cable connector is closed to the charging port of the remote/controller, the charging connector automatically connects in order to charge. The charging time is 3 hours.
Step1: Press ‘+’ and ‘-’ at the same time; Enter Menu Surface (Power button- confirm; ‘+’
& ’-’ scroll up and down)
Step2: Confirm ‘Mode’ option
Step3: Confirm ‘Speed Limit’ option
Step4: Press ‘+’ or ‘-’ to switch the SL mode to ‘ON’ or ‘OFF’; then confirm.
Step5: Choose ‘return’ option; then confirm, until you quit the Menu surface. ‘K’ on the screen means the speed limit mode is ON. Use the same method to go back to Settings; turn the SL mode ON or OFF
Step2: Confirm ‘Mode’ option
Step3: Confirm ‘Speed Limit’ option
Step4: Press ‘+’ or ‘-’ to switch the SL mode to ‘ON’ or ‘OFF’; then confirm.
Step5: Choose ‘return’ option; then confirm, until you quit the Menu surface. ‘K’ on the screen means the speed limit mode is ON. Use the same method to go back to Settings; turn the SL mode ON or OFF
If your remote is not paired to the board/battery, showing "NA" is normal. They have not connected therefore there is no speed readout. If your remote is paired but showing "NA" (no speed readout).
It's because the GPS signal is weak at the current spot, it may resume if you move to a spot with a better signal.
It's because the GPS signal is weak at the current spot, it may resume if you move to a spot with a better signal.
check video here: https://youtu.be/T2MS_-ER6W0
“Err.1” = Angle sensor initialization failed.
“Err.2” =SPI Flash initialization failed.
“Err. 3” = Angle sensor and SPI Flash initialization failed.
“Err. 4” = GPS failed.
“Err. 7” = Angle sensor initialization, SPI Flash initialization, and GPS failed.
“Err.2” =SPI Flash initialization failed.
“Err. 3” = Angle sensor and SPI Flash initialization failed.
“Err. 4” = GPS failed.
“Err. 7” = Angle sensor initialization, SPI Flash initialization, and GPS failed.
Immediately release the trigger of the remote control to stop the motor, turn off the remote control, lay on the board, and paddle back to land using your hands.
Turn on the remote control and check whether the Bluetooth icon is flashing. If it is flashing, restart the battery and pair again using Bluetooth. If the problem is still not resolved, please stop using and contact after-sales service in time.
Turn on the remote control and check whether the Bluetooth icon is flashing. If it is flashing, restart the battery and pair again using Bluetooth. If the problem is still not resolved, please stop using and contact after-sales service in time.